Table of Contents
Advertisement
2
Using two B screws, hand tighten the bracket to the
rack.
Caution
Do not tighten the screws completely. These
screws should only be tightened after the rail
assemblies have been mounted and you have
confirmed that the library can be mounted.
B screw
3
In the same manner, hand tighten all of the other
brackets as shown in the diagram. Make sure that
all four brackets are facing the correct way and are
mounted at the correct height.
Bracket
Align screw holes
Bracket
Mounting the Rail Assemblies on the
Brackets
1
Place a rail assembly in one set of brackets, slide the
rail assembly all of the way into the rack (1), and
then pull the slide rail out of the rail assembly (2).
Bracket
(2)
Slide rail
2
Align the screw holes in the rail assembly with the
screw holes in the brackets, and then use a C screw
to secure the back end of the rail assembly to the
bracket.
The position is easy to determine if you push the
rail assembly all of the way into the rack so that it
is touching the post in the back of the rack. If the
screw holes do not line up, use the slot to the side of
the round screw hole to fasten the rail assembly to
the bracket.
Use this slot if the screw
holes do not line up.
Note
Mounting is easier with the S screw, because you do
not need to use a nut.
3
Push the slide rail back into the rail assembly, and
then use a C screw to secure the front end of the rail
assembly to the bracket.
If you use the slots for fastening, be sure to
carefully align the rack and the rail assembly before
tightening the screws.
4
Mount the rail assembly on the other side in the
same manner.
Rail assembly
(1)
C screw
S screw
Rail assembly flush
against rack post
13
Preparation
Advertisement
Chapters
Table of Contents
