Table of Contents
Advertisement
Preparation
In order to mount the AIT library, first mount the rails
and brackets on the library and rack.
Before beginning work, always be sure to press the
power standby switch on the front panel of the AIT
library to turn off the AIT library, and then disconnect all
cables.
Pull Out the Inner Rails
Pull out the inner rails from the rail assemblies.
1
Pull out the inner rail from one of the rail
assemblies as far as it will go.
The rail can be extended until the locking arm on
the back of the rail emerges.
Rail assembly
2
Turn the rail assembly over. Press the locking arm
to release the lock, and then pull the inner rail all of
the way out.
3
Repeat the process with the other rail assembly,
pulling out its inner rail.
Note
The inner rail will be mounted on the AIT library,
while the rail assembly will be mounted on the rack.
Back of rail assembly
Locking arm
Inner rail
Preparing the Library
Mount the L-shaped brackets and inner rails on the
library.
Mounting the B Caps and L-shaped
Brackets
After you have removed the front panel and replaced the
A caps with the B caps, mount the L-shaped brackets.
Caution
• Electrostatic charges that build up on your body can
damage the components. Before starting work, touch
the metal chassis of the AIT Library.
• Do not touch any components other than those that
must be replaced. In the event of damage, a charge will
be assessed for repair.
1
Loosen the screws on both sides of the front panel.
2
To remove the front panel, check that the screws on
both sides are loose, then pull the front panel
horizontally in the direction of the arrows.
A cap
11
Preparation
Advertisement
Chapters
Table of Contents
