Sony DVP-NS300 Operating Instructions Manual page 44
Hide thumbs
Also See for DVP-NS300:
- Service manual (111 pages) ,
- Operating instructions manual (76 pages) ,
- Training manual (46 pages)
Table of Contents
Advertisement
To reset the TVS setting
In Step 2, select "OFF "
TVS (TV Virtual
Surround)
DYNAMIC
Uses sound imaging to create virtual rear
speakers from the sound of the front speakers
(L/R) without using actual rear speakers
(shown below) The sound imaging effect is
distinct and clearly reproduces each aural
element of the audio track
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV
TVS (TV Virtual
Surround)
WIDE
Uses sound imaging to create virtual rear
speakers from the sound of the front speakers
(L/R) without using actual rear speakers The
virtual speakers are reproduced as shown in
the illustration below This gives the sound
an expanded effect that fills the area
surrounding
the listener
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV
TVS (TV Virtual
Surround)
NIGHT
The large sounds, such as explosions, are
suppressed, but the quieter sounds are
unaffected This feature is useful when you
don't want to disturb other people but still
want to hear the dialog and enjoy the
surround sound effects of TVS WIDE
TVS (TV Virtual
Surround)
STANDARD
Uses sound imaging to create virtual rear
speakers from the sound of the front speakers
(L/R) without using actual rear speakers The
virtual speakers are reproduced as shown in
the illustration
below Use this setting when
you want to use TVS with 2 separate speakers
and retain the sound quality
L: Left front speaker
R: Right front speaker
: Virtual speakers
..".
c You can also change the TVS setting by pressing
SURROUND
on the player
If you select any TVS
setting othet than "OFF,"
the indicator on the player
lights up
l
When you select an effect, the sound cuts off fat a
moment
l
When the playing signal does not contain a signal for
the rear speakers (page43).
the surround effects may
be difficult
to hear
l
When you select one of the TV modes, turn off the
surround
setting of connected
TV or amplifier
(receiver)
l
Make sure that your listening position is between
and at an equal distance from your speakets, and that
the speakers are located in similar surroundings
Otherwise,
the TVS effect may be hard to discern
l
TVS NIGHT
only works with Dolby Digital discs
However,
not all discs will respond to the TVS
NIGHT
function
in the same way
l
If you use the DIGITAL
OUT (COAXIAL
and
OPTICAL)
jacks and set "DOLBY
DIGITAL"
to
"DOLBY
DIGITAL"
in "AUDIO
SETUP,"
sound
will come ftom your speakers but it will not have the
TVS effect
Advertisement
Table of Contents
