Table of Contents
Advertisement
"Stop/Fs&Spd=0". In this case the Start command must be recycled after Fast stop is no more
active in order to let the drive to start again.
Jog -
N
!
OTE
Start/Stop command takes priority over the Jog command. The Jog command can be
activated by concurrent sources: the [+/Jog] key on the keyboard, and a boolean source
that can be either a communication or application card or a programmable digital input. The
Jog command is complemented by a toggle command for rotation direction inversion. The
source of inversion may also be a dedicated key on the keyboard/display module or a
configurable source, both sources may be concurrently active.
N
!
OTE
Due to the double function of the keys, it is initially necessary to hit [Shift] and [+/Jog] in
order to turn the keyboard section into jog mode. After that, the simple pressure of [+/Jog]
key will cause the drive to jog, and the pressure of the [-/<->] key will cause inversion of the
rotation. To exit keyboard jog mode press [</Escape].
1.5.2 Command Block (Commands)
The command Block, via the input sources, allows to select the signal origin to control:
-
Term enable src
-
Term StrStp src *
-
Term Start src *
-
Term Stop src *
-
Dig enable src
-
Dig StrStp src
-
FastStop src
(*) The start and stop command can be controlled, as an alternative, via:
·
A single terminal
·
Two terminals connected with buttons
N
!
OTE
For factory setup see section 1.5.3.1
N
!
OTE
DI0, enable input, terminal point 12, has to be open to change parameter COMMANDS
SELECT from the keypad or toolbox.
Ch.1
60
this command provides momentary rotation of the drive with ramp and speed reference
settings independent of the ones defined for operation with Start/stop command.
command source for the terminal strip Enable
source of the Start (1) command and of the terminal strip Stop (0) command
command source for the terminal strip Start
command source for the terminal strip Stop
digital Enable command source
source of the Start (1) command and of the digital Stop (0) command.
Fast Stop command source
+ 24V
+ 24V
START
STOP
—————— Function Description ——————
GEH-6641E
In this case (+24) 1 refers to the Start and (open) 0 to the Stop
START=Closed, STOP=open
In this case the change of state is caused by the positive
front (0 to1) on the terminal.
+ 24V
START
STOP
- Quick Links:
- Drive Status Menu (Status)
Hide quick links:
Advertisement
Table of Contents
