Table of Contents
Advertisement
In this example, make the settings shown in the illustration in before page. Clicking a cross point (a square area) or
dragging cross points will switch it on/off. If you right-click on a cross point, a context menu appears. You can select
[All OFF] to turn off all cross points. The cross point shows the send level as the amount of green.
For each zone, this setting will be as follows.
Zone 1: Input channel 1, CD/BGM/SD (SDIN1–3), and the audio from the other MTX/MRX System are broadcast
to this entire MTX/MRX System. Since the mic (CH1) of this MTX/MRX System and the mic (CH9) of
the other MTX/MRX System are assigned for emergency announcements etc. for the entire building, spec-
ify their Priority in the "ZONE" screen that follows.
When you turn CH1 and CH9 on in the matrix, the (attenuated) signal from the matrix will be combined
with the signal from Priority, and output.
Zone 2: This is for broadcasting the voice from the main mic (CH1) to the other MTX/MRX System.
Zone 3: This is for broadcasting signals other than the main mic to the other MTX/MRX System.
For the input channel faders in the lower left of the screen, the grayed-out faders show input levels, and the other faders
show input channel send levels. Grayed-out faders cannot be operated in this screen.
Priority signal flow
ZONE 1-8
PAGING
PAGING
DUCKER
PAGING
SOURCE
From INPUT CHANNEL POST ON 1-16
From STEREO INPUT CHANNEL POST ON 1L-3R
From DIRECT INPUT POST ON 9-16
From ANC BUS 1-2
*1 From YDIF IN 1-16
*1 DISTRIBUTION MODE only
2nd PRIORITY
1st PRIORITY
GR
GR
PRIORITY
PRIORITY
DUCKER
DUCKER
MIX
MIX
MIX
PRIORITY
PRIORITY
SOURCE
SOURCE
Example 4) A system using Dante
ZONE OUT
ANC
MASTER
METER
LEVEL
D
ON
ANC
C
8
A
AMBIENT
To YDIF
METER
OUTPUT
AMBIENT
PATCH
SOURCE
MTX Setup Manual
102
- Quick Links:
- Input Settings
- Connecting the Equipment
Hide quick links:
Advertisement
Table of Contents
