Advertisement
Available languages
Available languages
Using the SmartClean system
Caution: Always shake excess water off the shaver before you place
it in the SmartClean system (Fig. 47).
1 Press to open the SmartClean system cap, to be able to place the
shaver in the holder ('click') (Fig. 16).
2 Hold the shaver upside down above the holder. Make sure the
front of the shaver points towards the SmartClean system holder
(Fig. 17).
3 Place the shaver in the holder (1), tilt the shaver backwards (2) and
press down the top cap to connect the shaver ('click') (3) (Fig. 18).
The battery symbol starts to flash, which indicates that the shaver
is charging.
4 Press the on/off button on the SmartClean system to start the
cleaning program (Fig. 48).
During the rinsing phase, the rinsing symbol flashes. When the rinsing
phase is done (after approx. 10 minutes), the rinsing symbol lights up
continuously (Fig. 48).
After the rinsing phase, the drying phase starts automatically. During
this phase, the drying symbol flashes. When the drying phase is done
(after approx. 4 hours), the drying symbol lights up continuously (Fig.
49).
When the cleaning program is done, the ready symbol lights up
continuously (Fig. 50).
30 minutes after the cleaning program and charging are done, the
SmartClean system switches off automatically.
The battery symbol lights up continuously to indicate that the shaver
is fully charged (Fig. 50). Charging takes approx. 1 hour.
Note: If you press the on/off button of the SmartClean system during
the cleaning program, the program stops. In this case, the cleaning or
drying symbol goes out.
Note: If you disconnect the SmartClean system from its power supply,
the cleaning program stops.
17
English
Advertisement
