Connecting To Web-Based Interface - D-Link DIR-615 User Manual
N300
Hide thumbs
Also See for DIR-615:
- User manual (208 pages) ,
- Quick installation manual (44 pages) ,
- Training manual (37 pages)
Table of Contents
Advertisement
DIR-615 Wireless N300 Router
User Manual
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
For security reasons, DIR-615 with default settings cannot connect to the Internet. To get
!
started, please set your own password used to access the web-based interface and, if
needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 13). In the address bar of the web
browser, enter the domain name of the router (by default, dlinkrouter.local) with a dot at
the end and press the Enter key. Also you can enter the IP address of the device (by default,
192.168.0.1).
Figure 12. Connecting to the web-based interface of the DIR-615 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Setup Wizard opens (see the Setup Wizard section, page 30).
Figure 13. The page for running the Setup Wizard.
Page 22 of 163
Installation and Connection
- Quick Links:
- Access Point or Repeater
Hide quick links:
Advertisement
Table of Contents
