Assign Device Names - Siemens RXB Series Basic Documentation

Knx bus communications

Hide thumbs

Table Of Contents

Table of Contents

Communication

Basic settings

Notes

Read other basic

settings

Home page

30 / 88

Siemens

Building Technologies

Communication

Basic settings...

Room...

Holidays/special days

Distribution zones...

Basic settings

Area:

Line:

Device address:

Dec bus power supp:

With access at the Service level, the setting values on the "Basic settings" page

are read-only values. This is indicated by the fact that the black bar does not cover

the whole operating line, i.e. the settings themselves are not highlighted.

In small networks, the KNX bus can be commissioned with the factory-set area

address 0 (zero) and line address 2. These addresses are permissible only if:

The Synco bus devices are installed in Area 0 and Line 2 of a network, and not

assigned to other areas and lines by means of super-ordinate area and line

couplers.

The other basic settings under "Communication" can be read by rotating the knob

clockwise.

Basic settings

Dec bus power supp:

Clock time op:

Master

Rem set clock slave:

Remote reset fault:

4.1.2