Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
View Hardware Information for the Selected Transcoder
At the [Card (#)] Command > prompt, type hwid and press Enter to view the selected
card's hardware ID (firmware version), for example:
Card HWID# is: 7710-v1.0-2010-1105
View Software Information for the Selected Transcoder
At the [Card (#)] Command > prompt, type ver and press Enter to view the selected
card's software versions, for example:
OS version:
Encoder version:
Ethernet version:
Application version:
View MUX Bitrate Data for the Selected Transcoder
At the [Card (#)] Command > prompt, type bits and press Enter.
MUX bitrate data for the selected transcoder card is displayed in millions of bits per second
(Mbit/s), for example:
HDMI Input Bitrate: 14.120 Mbit/s (raw 14.120 Mbit/s)
Ethernet Input Bitrate: 0 (raw 9.210 Mbit/s)
Data Output Bitrate: 16.881 Mbit/s
Total Output Bitrate: 19.396 Mbit/s
The example above shows MUX bitrate data for an HCS7710 card. Refer to the Installation &
Setup Guide for the applicable transcoder card for further information on bitrate data.
Install a Pro:Idiom Key on the Selected Transcoder
This command installs the Pro:Idiom encryption key on the selected transcoder card. To
install a Pro:Idiom key on all the transcoders, see "Install a Pro:Idiom Key on All
Transcoders" on page 34.
Caution: Do NOT initiate simultaneous menu sessions while a Pro:Idiom key
installation is in progress. Doing so will interfere with the active processes and
may corrupt the system configuration and/or cause the HCS6300 card to cease
normal operation.
Note: In order for a Pro:Idiom encrypted channel to be displayed, the receiver
must contain a Pro:Idiom decrypter, and the receiver must be configured to allow
decryption of the desired channel.
206-4122
HCS7710-905-2010-0910
1.1
1.0
2.5
(Continued on next page)
41
Advertisement
Table of Contents
