Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Transcoder Menu Commands
The following subsections describe how to access and use the Transcoder Menu commands.
Note: Refer to the Installation & Setup Guide for the applicable transcoder cards for further
information on transcoder configuration options.
Access the Transcoder Menu
1. Access the HCS6300 Main Menu as described on page 31.
2. At the [Main] Command > prompt, type card and press Enter.
3. At the Enter card number (1-12) > prompt, type the chassis slot number of the
transcoder card for which you wish to access configuration options. Then, press Enter.
The system identifies the card type and then displays a command prompt for the card
menu, for example:
Card #1 is: HCS7710
[HCS7710 (1)] Command >
4. At the Command > prompt, either:
• Press Enter to display the card menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the Command > prompt to display the Transcoder
Menu.
Example: Transcoder Menu
------------
HCS7710 Menu
------------
hwid
Read Hardware ID
ver
Read Software Versions
caget
Read Content Advisory Messages Setting
caset
Enable/Disable Content Advisory Messages
bits
Read MUX Bitrates
pi
Install PI Key
pr
Reload PI Key
cksum
Read PI Key Checksum
stb
Satellite Receiver Menu
upd
Update Firmware
irst
Internal Reset
ret
Return to Main Menu
[HCS7710 (1)] Command >
* These commands are applicable to HCS7700 and HCS7710 cards only. Refer to the LG Service
Bulletin on Content Advisory configuration options for further information.
40
*
*
206-4122
Advertisement
Table of Contents
