Table of Contents
Advertisement
Basic Installation and Operation Guide
RECEIVING, HANDLING/MOVING, AND UNPACKING
Receiving and Unpacking
Upon receipt of the equipment, do the following:
• All JK Series units are shipped in the vertical (upright) position and should be handled accordingly when received.
If the controller is not upright upon receipt, notify the carrier of possible damage. Upright the units as soon as
possible and immediately notify the nearest Toshiba representative.
• Carefully unpack the unit and make an immediate inspection for any concealed damage which might have
occurred during shipment. If damage is found, it should be noted with the carrier prior to accepting the shipment,
if possible. Report any damage immediately and file a claim with the freight carrier within 15 days of receipt.
• Verify that the starter description on your unit matches your purchase order. The starter information is located
on stickers in the medium voltage incoming compartment.
• Keep the equipment upright.
WARNING
CAUTION
Handling and Moving
Medium voltage controllers should be handled with
care to avoid damage to components, frame, and
finish (Fig. 1).
The capability of the moving equipment to handle
the weight of the controller shipping section should
be confirmed. The equipment should remain
secured to the shipping skid to prevent distortion of
the frame during moving and to minimize tipping.
Extreme care should be exercised during any
movement and placement operations to prevent
dropping or tipping.
WARNING
Using a Forklift
A forklift truck may offer a more convenient method
of handling the controller. A safety strap should be
used when handling with a forklift. The ends of the forks
should not enter the bottom of an open-bottom
enclosure.
TOSHIBA
Do not install or energize equipment that has been damaged.
Do not lay the equipment on its side or upside down.
Do not place any part of your
body beneath the equipment
being lifted. Improperly
secured equipment can fall
or tip over quickly and
without notice.
JK 400 Series Fixed Controllers
Fig. 1 Moving the Controller
1
Advertisement
Table of Contents
