Table of Contents
Advertisement
2.5
Power supply
2.5.1
Fitting the energy cable 5 x 1.5 with a power plug PRO
Introduction
The next section explains the individual steps assembling an energy cable with a power plug
PRO.
Note the information in the assembly instructions of the plug.
Connector pinout
An IE M12 plug PRO / IE FC M12 plug PRO with the pinning as shown in the following table
must be connected to both ends of the IE FC cable.
Table 2- 1
Pin number
Pin 1
Pin 2
Pin 3
Pin 4
The signal assignment in the table corresponds to the pin assignment of the 4-pin
10/100BaseTX M12 socket of SCALANCE X208 PRO.
The pin assignment of the M12 socket of a network component on the other hand is as
follows:
Table 2- 2
Pin number
Pin 1
Pin 2
Pin 3
Pin 4
The difference is that the send pin at one end must connect to the receive pin at the other
end. With straight-through cables, this is only the case if the connector pin assignment is not
the same at both ends. With devices that have autocrossing, a transmission would work
even if the pin assignment was the same.
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01
Instructions for fitting connectors, attachments and devices
Pinning at both ends of a straight-through cable
Pinning as a network component
RX+
TX+
RX-
TX-
Crossover pin assignment at one end of a crossover cable
Assignment
TX+
RX+
TX-
RX-
2.5 Power supply
Color
Yellow
White
Orange
Blue
White
Yellow
Blue
Orange
69
Hide quick links:
Advertisement
Table of Contents
