4
Planning
Building Technologies
Fire Safety & Security Products
Unique detector line topology recognition is ensured if at least one device with a
separating function is present between two sub-stub lines. In this case a line
separator.
If several sub-stub lines are to be activated on one FDnet/C-NET loop, failure of
large numbers of devices must be prevented in the event of a line short-circuit. In
this regard the national regulations must be observed. From a FDnet/C-NET
communication point of view, the line separator is a normal line participant which
occupies one bus address and is visible in the line topology.
The following figures show the common variants of a modernized detector line on
which the FDnet/C-NET devices (T) are installed with integrated line separation
function. The outgoing stub lines A to D are connected to the FDCL221 line
separators via terminal blocks or micro terminals (X).
Housing FDCL221 line separator in intermediate distributors
1 Intermediate distributor
2 FDnet/C-NET loop
3 FDCL221 line separator
A Sub-stub A
B Sub-stub B
C Sub-stub C
D Sub-stub D
T FDnet/C-NET device
X Terminal blocks or micro terminals
Planning
17
007063_e_en_--
09.06.2009