ABB ACH580 Series User Manual page 135
E-clipse bypass and packaged drive
Hide thumbs
Also See for ACH580 Series:
- Installation, operation and maintenance manual (157 pages) ,
- Quick start up manual (104 pages) ,
- Electrical planning instructions (36 pages)
Table of Contents
Advertisement
126
Instance
ID
BV10
BV11
BV12
BV13
BV14
BV15
BV16
BV17
BV18
BV19
BV20
BV21
BV24
Embedded fieldbus
ACH580 E-Clipse bypass and packaged drive user manual
Object Name
RUN/STOP CMD
This object commands a drive
start. Control requires bypass
parameter 1601 value = comm.
FWD/REV CMD
This object commands a motor
rotation direction change.
Control requires 20.11 =
request (0) and drive configured
to receive the reference over
the fieldbus.
RUN
This object commands Run
PERMISSIVE
Permissive. Control requires
CMD
parameter 1601 value = COMM.
EXT 1/2 CMD
This object selects EXT1 or
EXT2 as the active control
source. Control requires
parameter 19.11 value = EFB
MCW bit 11 (32).
FAULT RESET
This object resets a faulted
drive. The command is
rising-edge triggered.
MBOX READ
This object reads a parameter
(defined by AV25 MBOX
PARAM) and returns it in AV26
MBOX DATA.
MBOX WRITE
This object writes the data value
specified by AV26, MBOX
DATA, to a parameter (defined
by AV25, MBOX PARAM).
LOCK PANEL
This object locks the panel and
prevents parameter changes.
The corresponding drive
parameter is 96.02.
CTL OVERRIDE
This object commands the drive
CMD
into BACnet Control Override.
In this mode, BACnet takes
drive control from the normal
source. However, the control
panel's HAND mode has priority
over BACnet Control Override.
CTL OVERRIDE
This object indicates whether
ACT
the drive is in BACnet Control
Override. (See BV18.)
START
This object commands start
INTERLOCK 1
interlock1. Control requires
bypass parameter 1603 value =
COMM.
START
This object commands start
INTERLOCK 2
interlock1. Control requires
bypass parameter 1604 value =
COMM.
STARTED MON
This object indicates the drive's
started status.
Active/Inactive
Description
RUN/STOP
REV/FWD
ENABLE/
DISABLE
EXT2/EXT1
RESET/NO
READ/RESET
WRITE/RESET
LOCK/UNLOCK
ON/OFF
ON/OFF
ENABLE/
DISABLE
ENABLE/
DISABLE
START/NO
START
Present Value
Text
Access Type
C
C
C
C
C
W
W
W
C
R
C
C
R
Hide quick links:
Advertisement
Table of Contents
