Table of Contents
Advertisement
Figure 2-1
Module Level Command Syntax Diagram
AUToscale
Command
:AUToscale
The AUToscale command causes the oscilloscope to automatically select the
vertical sensitivity, vertical offset, trigger source, trigger level and timebase
settings for optimum viewing of any input signals. The trigger source is the
lowest channel on which the trigger was found. If no trigger is found, the
oscilloscope defaults to auto-trigger. The display window configuration is not
altered by AUToscale.
Example:
OUTPUT XXX;":AUTOSCALE"
Module Level Commands
AUToscale
2–3
Advertisement
Table of Contents
