Table of Contents
Advertisement
OIL PAN AND OIL PUMP STRAINER
[A] : Sealant application amount
"a" : 3 mm (0.12 in.)
"b" : 2 mm (0.08 in.)
1. Oil pan
: Apply sealant 99000-31150 to mating surface.
2. Strainer
4) Install exhaust manifold cover (1) .
5) Connect heated oxygen sensor coupler (2) and fit coupler to
bracket securely (if equipped).
6) Install heat insulator panel and front bumper with front grille
by referring to Section 9.
7) Connect negative cable at battery.
8) Check exhaust system for exhaust gas leakage.
3. O-ring
4. Gasket
5. Drain plug
6. Strainer bolt
7. Bracket bolt
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect heated oxygen sensor coupler and detach it from
its stay.
3) Remove oil level gauge.
ENGINE MECHANICAL (M13 ENGINE) 6A1-21
8. Oil pan nut
9. Oil pan bolt
Tightening torque
Do not reuse.
Advertisement
Table of Contents
