Single Line Telephones (Figure 6-2) - Samsung DCS-816 Programming Manual
Hide thumbs
Also See for DCS-816:
- Installation manual (44 pages) ,
- General description manual (42 pages) ,
- System administration and special features manual (32 pages)
Table of Contents
Advertisement
SAMSUNG
DCS-816
6.3 Single Line Telephones (Figure 6-2)
The DCS-816 system has four (4) SLT interfaces to which conventional telephones or OPX lines
can be connected.
connections can be done through the RJ-45 connector on the base board. See Figure 2-3 and
refer to section 2.5 (MDF Cabling).
Use one pair twisted wires and connect each telephone to the SLI port of your choice via the RJ-
45 connector on the base board.
4 PAIR CABLE WITH MALE CONNECTOR TO THE BASE RJ-45 CONNECTOR
CONNECTING SINGLE LINE TELEPHONES
The system requires MDF connection for single line telephones and all
RJ-45 CONNECTION
PIN COLOUR
1/ 8 W-BL/ BL-W
2/ 7 W-O/ O-W
3/ 6 W-GR/ GR-W
4/ 5 W-BR/ BR-W
² NO POLARITY
² A LOOP-DISCONNECT FACILITY PER LINE
² CONNECT A CONVENTIONAL TELEPHONE TO
ANY SLI CIRCUIT ON THE BASIC KSU
² TWO ANALOGUE TRUNK LINES WILL BE
AUTOMATICALLY TRANSFERRED TO SLI 3
(STN15) AND SLI 4 (STN16) IN CASE OF POWER
FAILURE. REFER TO SECTION 7.8 (216 BASE
KSU ONLY)
CIRCUITS/ FUNCTIONS
T/R, 1
T/R, 2
T/R, 3
T/R, 4
6-3
Installation
February, 1999
st
SLI on base board
nd
SLI on base board
rd
SLI on base board
th
SLI on base board
FIGURE 6-2
- Quick Links:
- Program List
- Set Answer Mode
Hide quick links:
Advertisement
Chapters
Table of Contents
