Sony Handycam DCR-HC1000 Operation Manual page 128
Digital video camera recorder
Hide thumbs
Also See for Handycam DCR-HC1000:
- Service manual (101 pages) ,
- Application manual (44 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
If you did not press the right spot, start from
step 4 again.
b Note
• You cannot calibrate the LCD screen if you have
rotated the LCD panel and set it with the LCD screen
facing out.
On handling the casing
• If the casing is soiled, clean the camcorder
body with a soft cloth lightly moistened with
water, and then wipe the casing with a dry soft
cloth.
• Avoid the following to avoid damage to the
finish.
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent and
insecticide.
– Handling with above substances on your
hands.
– Leaving the casing in contact with rubber
or vinyl objects for a long period of time.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent molds periodically clean the lens
as described above.
It is recommended you operate your camcorder
about once a month to keep it in an optimum
state for a long time.
To charge the pre-installed button-type
battery
Your camcorder has a pre-installed button-type
battery to retain the date, time, and other
settings even when the POWER switch is set to
(CHG) OFF. The pre-installed button-type
battery is always charged while you are using
your camcorder but it will get discharged
gradually if you do not use your camcorder. The
button-type battery will be fully discharged in
about 3 months if you do not use your
camcorder at all. However, even if the pre-
installed button-type battery is not charged, the
128
Additional Information
camcorder operation will not be affected as long
as you are not recording the date.
Procedures
Connect your camcorder to a wall outlet using
the supplied AC Adaptor, and leave it with the
POWER switch set to (CHG) OFF for more
than 24 hours.
Removing dust from inside the
viewfinder
1
2
1
Remove the eyecup.
1 Remove the screw on each side of the
eyecup and viewfinder using a
screwdriver.
2 Remove the eyecup.
2
Remove dust from inside the eyecup and
viewfinder with a blower.
3
Reverse steps 1 and 2 to re-attach the
eyecup and replace the screws.
b Note
• Do not drop or bend the eyecup shaft. Be careful
when handling the eyecup.
1
Hide quick links:
Advertisement
Table of Contents
