Table of Contents
Advertisement
Intake/exhaust vent
Air-cooling system is used in the laser marker, thus the cooling effect will drop if dust or oil is adhered to the intake or
exhaust vent and it may result in the failure of the laser marker. Clean them regularly according to the usage environment.
⿎ Cleaning of the intake/exhaust vent (Daily maintenance)
1.
Turn OFF the key switch of the controller, and disconnect the controller power cable.
2.
Vacuum the intake/exhaust vent and remove the dust.
LP-400 series
Intake air
Exhaust
LP-V/LP-W series
Notice
• Do not blow air to the laser marker especially to the intake/exhaust vent. If the dust penetrates in the laser marker, it may
results in failure.
3.
Wipe the vent with a dried cloth. If a contamination is severe, use a cloth wrung out with neutral
detergent to wipe it. Then, remove the detergent with a cloth wrung out of water.
Notice
• Keep water from entering the laser marker inside.
278
ME-LP400V-OP-6
- Quick Links:
- Error Log
- Error Indication
- Alarm
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
