Table of Contents
Advertisement
Installation of this unit
10
Move the top panel of the Base Module to the
module to be placed at the top.
≥ Lightly tighten the four thumbscrews to determine the
position and then tighten them firmly. Tighten the M3
screw.
≥ Rotate the thumbscrew while pushing it.
≥ This step is not required if the Base Module is to be
placed at the top.
Thumbscrew
≥ Remove the tape affixed to the four thumbscrews at the
interface side of the unit prior to installation, and make
sure the thumbscrews are fully tightened.
≥ If the thumbscrew is loose, tighten firmly.
≥ If the installation is completed with loose thumbscrews,
it may damage the unit or cause heavy objects to fall.
≥ Confirm that there is no
dust or dirt on the
surface of the changer
unit so that foreign
objects do not attach to
the disks while the
system is operating.
≥ Remove any dirt
exceeding 1 mm (0.04q) in diameter.
Preparatory work for installation
M3 Screw
23
Advertisement
Table of Contents
