Table of Contents
Advertisement
Installation of this unit
4
Adjust the positions of the mounting brackets.
≥ Each mounting bracket is fastened by two M3 screws
at the 14 mm (0.6q) position. (
Adjust the mounting bracket position as needed.
≥ Check the shape and orientation of the mounting
brackets to attach them correctly.
≥ Match the two locating protrusions on the mounting
bracket with the locating holes on the Bottom Module.
Locating holes
Screw holes
Locating protrusions
5
Remove packaging reinforcement plates.
≥ Packaging reinforcement plates are attached to the
bottom for protection of the unit during transportation.
Remove six screws and then remove the plates. Store
the screws and the plates safely.
Packaging reinforcement plates
Preparatory work for installation
14)
Mounting bracket
Screw holes
6
Remove the securing screw of the gear rack of
the Base Module or Extension Module.
≥ It is not necessary to remove the securing screw from
the Base Module when placing the Base Module at the
top.
≥ Remove the securing screws of the gear rack of all
modules except the module to be installed on the top.
≥ Store the securing screws you have removed. These
will be required for transport.
Left gear rack on the interface side
Right gear rack on
the interface side
Gear rack on the drawer side
20
Interface side
Interface side
Interface side
Advertisement
Table of Contents
