ALLPLEX track Personnel Transmitter
Figure 5.2: Selecting Transmitter Radio Frequency
Notice!
Remove the battery before setting the dip switches.
Use a white marker to indicate the configured RF on the back of the transmitter after setting
the dip switches.
Changes to the dip switches should be performed by administrators only.
Once the transmitter restarts after inserting the battery, the transmitter will emit a number of
beeping tones depending on the configured RF.
Radio Frequency
303.825 MHz
304 MHz
433.42 MHz
Table 5.1: Number of Beeping Tones after Restarting
5.2
Factory Reset
Factory reset should be performed by administrators only. Set both dip switches 1 and 2 to
the ON position. While pressing the Test and Alarm buttons, the transmitter resets after
inserting the battery. If the reset is successful, there will be 3 slow consecutive beep tones
every 1 second. After a successful reset, select the transmitter RF by setting the dip switches
as described in Selecting Transmitter Radio Frequency, page 10. If the reset is unsuccessful,
there will be 2 slow consecutive beep tones every 1 second.
Refer to the following table which lists the values that are being set for the respective features
following the factory reset.
Feature
Transmitter Type
Man-Down
Robert Bosch (SEA) Pte Ltd
Diagram
Radio Frequency
1
304 MHz (default)
2
303.825 MHz
3
433.42 MHz
Used for Factory Reset
Switch Number 1
Number of Beeping Tones
1
2
3
Value
Security
Disabled
Installation Manual
Enabling and Disabling Features | en
Switch Number 2
OFF
OFF
ON
ON
11
OFF
ON
OFF
ON
2014.03 | V1.0.0 | DL