Table of Contents
Advertisement
Installation Manual
Quidway Eudemon 200 Firewall
Step 1: Select a console terminal. Console terminal can be a standard ASCII terminal
possessing an RS-232 serial port, or a regular PC, but the latter is often used.
Step 2: Connect the cable. Power off the Eudemon200 firewall and console terminal,
and connect the RS-232 serial port to the console port on the RPU via a console cable.
Power on the Eudemon200 firewall after verifying the installation. If the Eudemon200 is
working normally, the system will display the equipment boot information on the
console terminal. For more information about that, refer to "Chapter 4 Boot and
Configuration".
3.6 Connect the Eudemon200 to LAN
I. Introduction to Ethernet interface
The Eudemon200 firewall provide the fixed 10/100Base-TX FE interface. For details of
its attributes, refer to the section "1.4.1 RPU".
II. Ethernet cable
10/100Base-TX Ethernet interface usually adopts the category 5 twisted-pair for
connection, as shown in the following figure.
Figure 3-9 Ethernet cable
Ethernet cables fall into two categories, i.e., straight-through cables and crossover
cables.
Straight-through cable: The wire sequences of the twisted pairs crimped in the
RJ-45 connectors at both ends are the same. It is used for connecting a terminal
device (e.g., PC and equipment) to a HUB or LAN Switch. The cables delivered
with the equipment are straight-through cables.
Crossover cable: The wire sequences of the twisted pairs crimped in the RJ-45
connectors at both ends are different. It is used for connecting two terminal
devices (e.g., PC and equipment). Users can make it as needed.
For the pinouts of the cables and the making procedures, refer to "Appendix A".
3-8
Chapter 3 Installation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
