Configuring The Modbus Tcp Protocol - Siemens RX1500 User Manual
Ruggedcom rox ii series
Hide thumbs
Also See for RX1500:
- Installation manual (60 pages) ,
- User manual (664 pages) ,
- Reference manual (148 pages)
Table of Contents
Advertisement
Chapter 3
Device Management
Click the + symbol next to setdnp. The DNP Protocols Configuration form appears.
3.
Figure 124: DNP Protocols Configuration Form
1. Address Learning Box
4.
Configure the following parameter(s) as required:
Parameter
address-learning
aging-timer
max-connection
5.
Add a Device Address table. For more information about adding Device Address tables, refer to
Section 3.21.10.2, "Adding a Device Address
6.
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7.
Click Exit Transaction or continue making changes.
Section 3.21.7
Configuring the Modbus TCP Protocol
To configure the modbus TCP protocol for a serial port, do the following:
1.
Change the mode to Edit Private or Edit Exclusive.
2.
Navigate to interface » serial » {interface} » protocols » tcpmodbus » settcpmodbus, where {interface}
is the serial port. The Modbus TCP Configuration form appears.
124
1
2
3
2. Aging Timer Box
3. Max Connection Box
Description
The interface to learn the RTU address from.
Default: 1000
The length of time a learned DNP device in the Device Address Table may go without
any DNP communication before it is removed from the table.
Default: 1
The maximum number of incoming DNP connections.
Table".
RUGGEDCOM ROX II
User Guide
Configuring the Modbus TCP Protocol
- Quick Links:
- Connecting Directly
Hide quick links:
Advertisement
Table of Contents
