Chapter 3
Device Management
Section 3.16.3
Viewing a List of Line Module Configurations
To view a list of line module configurations, navigate to chassis » line-modules. If line modules have been
configured, the Modules table appears.
Figure 83: Modules Table
If no line modules have been configured, install line module as needed. For more information, refer to
Section 3.16.2, "Installing a New Line
Section 3.16.4
Configuring a Line Module
To configure a line module, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2.
Navigate to chassis » line-modules » {module}, where {module} is the line module. The Modules form
appears.
Figure 84: Modules Form
1. Detected Module
3.
Configure the following parameter(s) as required:
82
Module".
2. Module Type List
3. Admin State Check Box
Viewing a List of Line Module Configurations
RUGGEDCOM ROX II
User Guide