HP MSR2000 Configuration Manual page 121

Msr series mpls

Hide thumbs Also See for MSR2000:

Table of Contents

Use RSVP-TE to establish an MPLS TE tunnel from Router A to Router C. Enable CRLSP hot backup for the

tunnel to simultaneously establish a primary CRLSP and a backup CRLSP. When the primary CRLSP fails,

traffic is switched to the backup CRLSP.

Figure 31 Network diagram

Table 6 Interface and IP address assignment

Configuration procedure

Configure IP addresses and masks for interfaces. (Details not shown.)

Configure IS-IS to advertise interface addresses, including the loopback interface address. (Details

Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE:

# Configure Router A.

<RouterA> system-view

[RouterA] mpls lsr-id 1.1.1.9

[RouterA] mpls te

[RouterA-te] quit

[RouterA] rsvp

[RouterA-rsvp] quit

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] mpls enable

[RouterA-GigabitEthernet2/1/1] mpls te enable

[RouterA-GigabitEthernet2/1/1] rsvp enable

Show Quick Links

Table of Contents