Table of Contents
Advertisement
12
Table Top Assembly Continued
Locate the following parts and lay them out as indicated
on the template as shown in Figure 4.
2
8981 021 266 Profile, 45x60 with S12x30
Connection Screw
1
8981 021 147 Profile, 45x90H
2
8981 992 026/870 Profile, 45x45
These profiles will form the frame for the underside of
the table.
NOTE: The Inset Drawing on Figure 4 is shown
reversed for clarity.
INSET
45x90
45x60
Profile
Profile
W/Inserts
Slot
S12x30
Connection
Allen Wrench
Screw
Bottom Of Table Top
And Template
Figure 4
P/N 898 102 1147
45x45 Profile
P/N 898 199 2026/870
Acces
Hole
8mm
Slide the head of a S12x30 connection screw,
attached to the 45x60 profile, into the 45x90 profile
T-slot as shown in the Inset drawing on Figure 4.
NOTE: Position the 45x60 profile to extend
slightly beyond the end of the 45x90 profile.
This will allow room for the end cap that will be
installed in a later step.
Align the edges over the outline on the layout template.
Then use a 8mm allen wrench and tighten the S12
screw through the access hole in the back side of the
45x90 profile.
Attach the remaining 45x60 profile with S12x30 to
the other end of the 45x90 profile.
45x90H Profile
45x60H Profile
S12x30 Connection Screw
P/N 898 102 1266
Advertisement
Table of Contents
