Table of Contents
Advertisement
Table Top Assembly
NOTE: The adjustable table is assembled upside
down. In the following steps make sure the
table top is positioned with the bottom side up.
Locate the layout template in your parts kit. Unroll it
and center it on the bottom side of your tabletop.
Carefully align the front and back edges of the template
making sure it is centered between the left and right
edges of your table top as shown in Figure 3, then
tape it in place.
HELPFUL HINT: When drilling pilot holes in the
table top, measure the depth on your drill bit
first and mark it. Then wrap tape around the drill
bit to show how far to drill.
Tape Template To
Bottom Of Table Top
Figure 3
Drill 2 mm pilot holes 18 mm deep for the control box
in each of the 4 locations indicated on the layout
template as shown in Figure 3.
Decide which switch location you are going to use.
Then drill 2 mm pilot holes 18 mm deep at each of the
3 indicated locations for the switch as shown in
Figure 3.
Drill 3 mm pilot holes 30 mm deep at each of the 4
corner locations on the layout template as shown in
Figure 3.
Check carefully to insure that you have drilled all of the
necessary pilot holes.
Optional
Switch Mounting
11
Advertisement
Table of Contents
