Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the M8 back-geared motor:
Remove / Assembly:
1. Remove the rear housing of the stacker.
2. Disconnect the wire of the faulty back-geared motor.
3. Unscrew the back-geared motor and remove the chain.
4. Remove the back-geared motor and replace it by a new one.
5. Put the chain back and adjust it using the back-geared motor.
6. Connect the wire on the new back-geared motor.
7. Switch on the machine, check the tension of the chain and tighten it if necessary.
8. Put back the frame.
Replacement of the M9 back-geared motor:
Remove / Assembly:
1. Remove rear housing of the stacker.
2. Disconnect the wire of the faulty back-geared motor.
3. Remove the rod linkage and the hub of the back-geared motor.
4. Unscrew the back-geared motor and remove the chain.
5. Remove the back-geared motor and replace it by a new one.
6. Put the chain back and adjust it using the back-geared motor.
7. Put the rod linkage and the hub on the new back-geared motor.
8. Connect the wire on the new back-geared motor.
9. Switch on the machine, check the tension of the chain and tighten it if necessary.
10. Put back the frame.
Replacement of the M10 back-geared motor:
Remove / Assembly:
1. Remove rear housing and the right side frame of the stacker.
2. Disconnect the wire of the faulty back-geared motor.
3. Remove the guide tension to release the chain.
4. Remove the chain.
5. Remove the back-geared motor and replace it by a new one.
6. Put the chain back and adjust it using the back-geared motor.
7. Connect the wire on the new back-geared motor.
8. Switch on the machine, check the tension of the chain and tighten it if necessary.
9. Put back the frame.
04102011/GB
06.2009
(electricity, steam, water, gas, compressed air...).
Stacker
37
7