Table of Contents
Advertisement
OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Step
Operation
7
Configuring the Layer 2 switching
feature
l Creating MAC Address Entries
l Modifying Aging Time of MAC
Addresses
l Configuring the Spanning Tree
8
Configuring QoS
9
Testing Ethernet Service Channels
10
Setting Performance Monitoring
Parameters of an NE
11
Backing Up the NE Database to the
SCB Board
4.4 Configuring EPL Services on an Ethernet Transparent
Transmission Board
EPL services provide the point-to-point Ethernet transparent transmission solution with the
bandwidth exclusively occupied. EPL services are applicable when the communication
equipment that is used to access the client-side data in the transmission network does not support
VLANs or when the VLAN planning must be kept secret to the network operator.
4.4.1 Networking Diagram
Issue 02 (2011-06-30)
Remarks
Optional
l You can manually specify the port for forwarding the MAC
frames to create the VLAN unicast entries and you can
suppress the forwarding of certain MAC frames to create the
MAC address disabled entries. The manually created MAC
entries are not affected by the aging time.
l The aging time of the dynamic MAC address entries of an
Ethernet switching board is five minutes by default. You can
modify the aging time according to the actual requirements.
l There may be loops in the network topology of Ethernet
services. Hence, the STP/RSTP protocol is enabled to prevent
packets from being proliferated and endlessly cycled in the
loop network.
l When a multicast router is located on the network, the IEEE
802.1q or IEEE 802.1ad bridge can enable the IGMP
Snooping protocol to work with the router, thus implementing
the multicast function.
Optional
The services of different users need to share the bandwidth. If the
services of different users need to be configured with different
quality levels, you need to adopt the corresponding QoS scheme.
Required
After the Ethernet services are created, test the service continuity.
Required
Enable the performance monitoring function for a specific NE.
Then, you can obtain detailed performance records during the
operation process of this NE. These records can be used for
monitoring and analyzing the running status of this NE.
Required
Back up the NE database to ensure that the NE can be
automatically recovered to normal operation after the SCC data
is lost or after the equipment is powered off.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
4-33
- Quick Links:
- Starting or Shutting down the U2000
Hide quick links:
Advertisement
Chapters
Table of Contents
