Installing Navigator 2; Changing The Storage Management Pc Ip Address - Hitachi AMS 2100 Hardware Manual
Hide thumbs
Also See for AMS 2100:
- Getting started manual (54 pages) ,
- User manual (210 pages) ,
- Service manual (192 pages)
Table of Contents
Advertisement
Installing Navigator 2
This section describes the procedure to install the Navigator 2 software.
Changing the storage management PC IP address
To connect the array and the storage management PC to a network, the
storage management PC IP address must be changed temporarily.
NOTE:
•
This procedure is not necessary if you are connecting the array with IPv6 from the
storage management PC.
•
If you are connecting the management PC to the array with IPv4 or other cable,
perform this procedure.
Complete the following steps to change the Storage Management PC IP
address:
1. Connect the 10/100 Ethernet Management Port on the array (controller
#0) and the storage management PC with a CAT-5 Ethernet cable.
2. Open a command (DOS) window and use the command ipconfig to find
out the IP address of the management console.
3. Record this address as you will need to reset the management console
back to that address later.
4. The default IP addresses of the management ports on the AMS 2100/
2300 are:
•
Controller 0: 192.168.0.16
•
Controller 1: 192.168.0.17
5. If the IP address of the management console does not match the default
subunit of the management ports, configure the management console
to use an IP address that matches the default subnet (192.168.0.x) of
the management port.
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
7–13
- Quick Links:
- Ams 2100 Base Unit
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
