Siemens SITRANS LG250 Operating Instructions Manual page 18

Guided wave radar, foundation fieldbus coax probe

Hide thumbs Also See for SITRANS LG250:

Table of Contents

Connection procedure

Proceed as follows:

1. Unscrew the housing cover

2. If a display and adjustment module is installed, remove it by turn-

ing it slightly to the left.

3. Loosen compression nut of the cable entry gland

4. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.

1 cm (0.4 in) of insulation from the ends of the individual wires

5. Insert the cable into the sensor through the cable entry

Fig. 7: Connection steps 5 and 6 - Single chamber housing

Fig. 8: Connection steps 5 and 6 - Double chamber housing

6. Insert the wire ends into the terminals according to the wiring plan

SITRANS LG250 - Operating Instructions

PBD-51041056

Table of Contents