Connecting To The Dc Output Terminal; Connecting The <Dc Out/Rs> Terminal To The External Recording Start/Stop Switch; Connecting To The <Dc Out> Terminal; Power Supply - Panasonic VariCam LT Operating Manual
Hide thumbs
Also See for VariCam LT:
- Operating manual (182 pages) ,
- White paper (22 pages) ,
- Operating manual (2 pages)
Table of Contents
Advertisement
Connecting to the DC output terminal
Connecting the <DC OUT/RS> terminal to the external recording start/stop switch
The <DC OUT/RS> terminal can supply 1.0 A current.
Recording start/stop can be controlled by connecting an external switch to this terminal.
An LED connected to this terminal can also be used as a tally lamp. This is useful for shooting video when fixing the camera on a crane.
1 GND
2 TALLY OUT
Open collector output on the camera side
Tally lamp on
Tally lamp off
3 Recording start/stop switch
This is connected in parallel to the <REC> button on the camera or the VTR button on the lens.
4 +12 V
NOTE
@
t Make sure that polarity is correct before connecting an external device. Otherwise, it may result in a malfunction.
Connecting to the <DC OUT> terminal
The <DC OUT> terminal can supply 1.0 A current.
This terminal can be used for the following purpose.
f Standard DC power supply output
f Power supply output and data communication to the electronic HD color view finder AU-VCVF10G
1 GND
2 Data communication (from the electronic HD color view finder to the camera)
3 Data communication (from the camera to the electronic HD color view finder)
4 +12 V
NOTE
@
t Make sure that polarity is correct before connecting an external device. Otherwise, it may result in a malfunction.
Chapter 3 Preparation — Connecting to the DC output terminal
<DC OUT/RS> terminal
Low impedance
High impedance
4
1
3
2
(Connection example)
4
1
3
2
LED
Resistance
Cable connector
HR10A-7R-4SC (73)
Hirose Electric Co.
– 32 –
Cable connector
HR10A-7R-4SC (73)
Hirose Electric Co.
Recording
start/stop
Advertisement
Table of Contents
