Mounting the module
Mounting the control panel
The control panel is used by connecting the control panel cable to the <CONTROL PANEL> terminal at the rear of the camera.
Normal operation may not be possible when the control panel is mounted or removed while the power is turned on.
Set the power switch to <
> when mounting or removing the control panel.
It can be mounted to the rear of the camera using the supplied dedicated mounting part.
1
Mount the control panel mounting part using the four supplied screws. (Fig. 1)
2
Mount the control panel onto the control panel mounting part. (Fig. 2)
3
Push down the lock lever to the right to lock. (Fig. 3)
4
Connect the cable of the control panel to the <CONTROL PANEL> terminal. (Fig. 4)
Panning operation/tilting operation
The angle or the tilt of the control panel can be adjusted.
NOTE
@
t Use the cable clamp to prevent the cable from getting snagged.
Chapter 3 Preparation — Mounting the module
Fig. 1
Fig. 3
Fig. 2
<CONTROL PANEL> terminal
Fig. 4
– 20 –