Table of Contents
Advertisement
Charging the SB1
CAUTION
Out of the box, the SB1 is off and displays the Regulatory label information.
Out of the Box Screen
Figure 1-2
Use the Single Slot Charging cradle or Ten Slot Charge Only cradle to charge the SB1. Refer to the SB1
Integrator Guide for accessory setup information.
To charge the SB1, slide it into the cradle slot with the Scan button facing up.
LED
Single Slot Charging Cradle
Figure 1-3
When the SB1 powers up a beep sounds and the Calibration screen displays.
Carefully press and briefly hold finger tip on the center of the Calibration screen target. Repeat the procedure
as the target moves and stops at different locations on the screen.
Follow the guidelines for battery safety described in
The SB1 must be charged within the 0 °C to +40 °C (32 °F to 104 °F) ambient temperature range.
Scan Button
Getting Started
Battery Safety Guidelines on page
1 - 3
5-1.
Advertisement
Table of Contents
Troubleshooting
