Siemens SINUMERIK 840D sl Operating Manual page 350

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Programming technological functions (cycles)

10.1 Drilling

Adapting the technology:

The technology fields are only displayed if their display has been enabled.

Please observe the information provided by your machine manufacturer.

Exact stop (only

● Empty: Behavior the same as it was before the cycle was called

for technology,

● G601: Block advance for exact stop fine

● G602: Block advance for exact stop coarse

● G603: Block advance if the setpoint has been reached

Precontrol (only

● Empty: Behavior the same as it was before the cycle was called

for technology,

● FFWON: with precontrol

● FFWOF: without precontrol

Acceleration (only

(only in mode "without compensating chuck")

for technology,

● Empty: Behavior the same as it was before the cycle was called

● SOFT: Jerk-limited (soft) acceleration of the axes

● BRISK: Abrupt acceleration of the axes

● DRIVE: Reduced axis acceleration

Spindle (only for

(only in mode "without compensating chuck")

technology, yes)

● Speed controlled: Spindle for MCALL: Speed-controlled operation

● Position controlled: Spindle for MCALL: Position-controlled operation

Parameters in the mode "Input simple" (only for G code program)

G code program parameters

Input (only for G code)

Retraction plane

Acceleration

Operating Manual, 05/2017, A5E40868956

Sinumerik 840de sl Sinumerik 828d