Table of Contents
Advertisement
Figure 209: Interface Routing: Example 1
Example 2: Segments and Target on the Same Subnet
In the example below (see
CS800 has two segmented interfaces, one for data and management traffic, and one for
replication traffic:
The source ETERNUS CS800 management/data IP address, the source ETERNUS CS800
l
replication IP address, and the target ETERNUS CS800 IP address are all on the same
subnet (192.168.10.x).
To make sure the replication segment is used when communicating with the target
l
ETERNUS CS800, you must add a host route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify the following routing details for the replication
interface on the source ETERNUS CS800:
Destination
Dest Netmask
Dest Gateway
ETERNUS CS800
"Interface Routing: Example 2" on page
Use the IP address of the target ETERNUS CS800
(192.168.10.200).
Use 255.255.255.255.
Use the replication IP address of the source ETERNUS
CS800 (192.168.10.100).
10.9 System
306), the ETERNUS
305
- Quick Links:
- Eternus Cs800 S6 Hardware
Hide quick links:
Advertisement
Table of Contents
