Setting up the machine
2.8 MDA
2.8.3
Executing an MDA program
Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
• Executing the program block-by-block
• Testing the program
• Setting the test-run feedrate
See also
Program control (Page 68)
54
1.
Select the "Machine" operating area.
2.
Press the "MDA" key.
The MDA editor opens.
3.
Input the desired G-code commands using the operator's keyboard.
4.
Press the "CYCLE START" key.
The control executes the input blocks.
Settings under program control
Settings under program control
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
HMI sl Universal