Table of Contents
Advertisement
66
Port output does not go to a file.
Only port output directed to a file may be rewound with the Memory Port
Rewind Output command.
67
This breakpoint is already set.
An attempt was made to set a breakpoint that already exists. The current
breakpoint must be deleted before it can be reset.
68
Port value not found.
A port was specified that has not been created with the Memory Inport Assign
or Memory Outport Assign command.
69
Address in range already specified as Read_Only or Guarded.
An address that was previously specified with a Memory Map Read_Only or
Memory Map Guarded command was specified. Memory Map Read_Only and
Memory Map Guarded commands can only act on Write_Read areas.
70
Arguments do not match any Read_Only or Guarded area.
The arguments specified with a Memory Map Write_Read command do not
match the corresponding Memory Map Read_Only or Memory Map Guarded
command. The arguments must match exactly. Entering a Memory Map Show
command gives a map of Read_Only and Guarded areas.
71
Address range contains unacceptable breakpoints.
An illegal breakpoint was specified.
72
Bad size specification for window.
An illegal size specification was given for a window. See the Window New
command for the correct size specifications.
73
Cannot repeat a cycle count of zero.
A Program Interrupt Add command qualifier cannot request that an interrupt
occur every zero cycles; this would cause an infinite loop.
Chapter 12: Debugger Error Messages
491
Advertisement
Table of Contents
