Table of Contents
Advertisement
34
Cannot divide by zero.
An attempt was made to divide by zero within an expression of Expression
Display_Value or Expression C_Expression.
35
This feature not available in this version.
51
This command cannot be used in this mode.
A command that is not supported in the current mode was issued. The
Program Display_Source command is only supported in high-level mode, and
the Memory Display Mnemonic command is only supported in assembly-level
mode.
52
Switches cannot be used together.
Two switches of the same group were given. Only one switch per group may be
specified.
53
Invalid switch given for this command.
The specified qualifier is not associated with the specified command. Check
the command syntax and re-enter the command.
54
Value too large.
A value that is out of range was specified. Values must be in the valid range for
the command.
55
Instruction expressions are invalid in this mode.
An expression was used for a code address in high-level mode. Only a single
line number or function symbol may be used in high-level mode.
56
Module not found.
The specified module name does not exist. Specify a valid module name.
Chapter 12: Debugger Error Messages
489
Advertisement
Table of Contents
