Disassembly/Reassembly Procedures: Radio Reassembly
2. Torque all seven Chassis Screws (25†††) with a Torx IP6 Bit and a Torque Driver to 3.0 in-lbf
in the sequence as shown in
8.6.4
Reassemble the Main Subassemblies (A and B)
1. Complete the steps in
2. Connect the connector on main flex to main board. Slide the Chassis assembly into the Front
Housing as shown in
NOTE: Main Flex needs to be seated properly before assembly.
7
2
3
6
Figure 8-20. Torque in the Chassis Screws.
Section 8.6.2.
Figure 8-21.
Figure 8-21. Slide chassis assembly into Front Housing
Figure 8-20.
4
5
1
through
Section 8.6.3.
Chassis Screws
Secondary Shield
8-17