Configuration Examples; Lacp Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP FlexFabric 12500 Series Configuration Manual
Routing
Hide thumbs
Also See for FlexFabric 12500 Series:
- Configuration manual (402 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
Configuration examples
This section provides IRF configuration examples for two-chassis and four-chassis IRF fabrics that use
different MAD mechanisms.
By default, Ethernet, VLAN, and aggregate interfaces are shut down. You must use the undo shutdown
command to bring them up.
LACP MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
As shown in
Configure LACP MAD on the multichassis aggregation to Device C, an HP device that supports extended
LACP.
Figure 16 Network diagram
Configuration procedure
IMPORTANT:
Between two neighboring IRF members, IRF links must be bound to IRF-port 1 on one member and to
IRF-port 2 on the other.
1.
Configure Device A:
# Assign member ID 1 to Device A, and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
Figure
16, set up a two-chassis IRF fabric at the access layer of the enterprise network.
41
Advertisement
Table of Contents
