Hitachi Compute Blade 500 Series User Manual page 299
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Figure 7-66 Selecting a Disable of the" NTP"
•
Save the configuration using [F9]: Save Configuration on the Menu
screen.
Figure 7-67 Saving the LPAR manager Config
How to set the IP address of NTP server
Note:
•
Confirm NTP configurations and TimeZone value of NTP servers before
configuring IP addresses of NTP servers.
•
Input IP address with format XXX.XXX.XXX.XXX, otherwise the input fails.
Place the cursor on NTP server1 or 2 at the lower left side and press [Enter]
to display a sub-screen, input the IP address of NTP server, and press
[Enter].
When you release the NTP settings, delete the IP address of NTP server on a
sub-screen, and press [Enter]. "None" will be displayed after the release.
How to change the LPAR manager system time
Enter new system time on the sub-screen which is displayed on the Date and
Time screen by pressing F6 key. (Configurable range of year is 2000 through
2099)
Note:
•
The year part of system time has to be set to a value between 2000 and
2037. If system time has not been set properly, LPAR manager system
time cannot be changed correctly on the LPAR manager screen.
And the year part of LPAR manager system time and LPAR SET time can
be set to a value between 2000 through 2099. However it's not
guaranteed that LPAR manager system time changes properly when LPAR
manager system time is not set to a value between 2000 and 2037.
Therefore set the value between 2000 and 2037 to the year part of LPAR
manager system time and LPAR SET time.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
7-95
Advertisement
Table of Contents
