Table of Contents
Advertisement
1 - 2
FX Series RFID Readers Integrator Guide
Port 1
Antenna Ports (Four Ports, Reverse TNC)
FX Series RFID Reader Rear Panel Connections
Figure 1-1
Step 2, Host Name Connect
The product CD provides the Host Name. Connect the reader to the local network and boot it up. See
Start-up/Boot LED Sequence on page
Open a browser. Recommended browsers are IE 6 or Mozilla 3.
1.
Enter the host name provided on the CD in the browser (e.g., http://fx7400cd3b0d) and press
2.
The
3.
Console Login
Proceed to
Step 3, First Time / Start-Up Login on page 1-3
4.
NOTE Connect the reader to a network that supports host name registration and lookup to ensure the network
can access the reader using the host name. For instance, some networks can register hostnames
through DHCP. When first connecting to the reader, it is recommended to keep DHCP enabled, although
it is not guaranteed that hostname will work in this case. Use the host name provided on the CD label, or
construct it using the reader MAC address on the reader back label. The host name is a string with prefix
FX7400, followed by the last three MAC address octets. For example, for a MAC address of
00:15:70:CD:3B:0D, use the prefix FX7400, followed by the last three MAC address octets (CD, 3B, and
0D), so the host name is FX7400CD3B0D. Type http://FX7400CD3B0D in the browser address bar to
access the reader.
Port 2
Port 3
Port 4
Reset
3-5. The green power LED indicates that the reader is ready.
window appears and the reader is ready.
GPIO
USB
10/100BaseT Ethernet
GPIO
(with POE)
to log in to the reader.
24 VD
Power
System
.
Enter
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
