Bit 5—Mode 10 Pin Monitor (MD10): Monitors the
reset by means of the
Bit 5: MD10
0
1
Bit 4—Mode 9 Pin Monitor (MD9): Monitors the
by means of the
Bit 4: MD9
0
1
Bit 3—
Output (SERR): Software control of
8 (SER) of the PCICONFI register is "1". When "1" is written to this bit,
clock. This bit always returns "0" when read. Used when the PCIC is not the host. If used when
the PCIC is the host, an
Bit 3: SERR
0
1
Bit 2—
Output (INTA): Software control of
Bit 2: INTA
0
1
Bit 1—PCIRST Output Control (RSTCTL): Controls the
on reset before output. This field is reset only at a power-on reset. Do not use the field when the
PCIC is non-host.
Bit 1: PCIRST
0
1
pin.
Description
Host bridge function (arbitration) enabled
Host bridge function disabled
pin.
Description
PCICLK used as PCI clock
Feedback input clock from CKIO used as PCI clock
assert interrupt is generated for the SH7751 Series.
Description
pin at Hi-Z
Assert
(Low output)
Description
pin at Hi-Z (driven to High by pull-up resistor)
Assert
(Low output)
Description
Negate
(High output)
Assert
(Low output)
/MD10 pin value in a power-on
/MD9 pin value in a power-on reset
output. This bit is valid only when bit
(valid only when PCIC is not host)
output. ORed with a power-
Rev. 3.0, 04/02, page 841 of 1064
is asserted for 1
(Initial value)
(Initial value)
(Initial value)