Table of Contents
Advertisement
19 | Enhancements
154 / 160
Following position definitions are possible: Front, Rear, Center, Gearbox, Front
Left, Front Right, Rear Left, Rear Right
At delivery no mounting location is set. This is signaled by an orange 'RUN' led
on the device. Therefore one must first assign a mounting location to the M 60
before it can be used in the project. The mounting location is permanently saved
in the M 60. If necessary you can at any time reassign a different mounting loca‐
tion following the same procedure.
A mounting location must not be used several times in one network, this would
disturb the functionality of the respective M 60.
1. In the Project Tree right click on the project name e.g. 'New Project' and then
select 'Show discovered devices...'
All connected M 60 are listed.
Compare the listed device Type, F‐Number and Serial Number to the identifica‐
tion plate to identify the device you want to make changes to:
DDU 7 Manual
Bosch Motorsport
Advertisement
Table of Contents
Troubleshooting
