Siemens SIMATIC IPC627D Operating Manual page 20
Hide thumbs
Also See for SIMATIC IPC627D:
- Operating instructions manual (186 pages) ,
- Product information (12 pages)
Table of Contents
Advertisement
BIOS Setup (SCU)
3.4 Advanced menu
Parameter
SATA Controller
HDC Configure As
Chipset SATA Mode
SATA Port # Device Type
SATA Port # HotPlug
Serial ATA Port #
Depending on the ordered device configuration
1
Only with IPC4x7
2
NOTICE
Data loss
RAID array information can be deleted on the disks when switching from "RAID" to "AHCI"
or "IDE".
This will result in a malfunction of the device or system.
Note
"RAID" may not be selected in conjunction with the SAS hardware RAID controller.
20
Meaning
Enables (Enabled) or disables (Disabled) the SATA port.
The names of the controllers are displayed below this.
IDE
AHCI
RAID
1
Hard Disk Drive
2
Solid State Drive
Enables (Enabled) or disables (Disabled) the HotPlug function. With
2
the HotPlug function, external SATA drives can be plugged or
uplugged during operation (eSATA socket).
If the SATA port no. # is occupied with a drive, its type is displayed,
otherwise "Not Installed". If no drive is connection the parameter is
grayed out.
The connected serial ATA hard disks are used as
parallel ATA data media.
The SATA ports are operated in the Advanced
Host Controller Interface mode (AHCI). Features
such as "Native Command Queuing" (NCQ) are
then supported, if NCQ-compliant hard disks are
installed. The operating system and the drivers
must also support AHCI mode.
The SATA ports are operated as a Redundant
Array of Independent Disks system (RAID). At least
two identical serial ATA hard disks must be
connected.
The driver is informed about the disk type of hard
disk (HDD). The display in the device manager and
the timing are adjusted.
The driver is informed about the disk type SDD.
The display in the device manager and the timing
are adjusted.
Operating Manual, 05/2016, A5E33664825-AB
BIOS Description
Hide quick links:
Advertisement
Table of Contents
