Table of Contents
Advertisement
Chapter 2 Front-Panel Menu Operation
To output a burst waveform
To output a burst waveform
You can configure the function generator to output a waveform with a
specified number of cycles, called a burst. You can output the burst at a
rate determined by the internal rate generator or the signal level on the
rear-panel Ext Trig terminal. For this example, you will output a
three-cycle sine wave. You will not change the other parameters from
their default settings: internal burst source, 0 degree starting phase,
and 100 Hz burst rate.
1 Select the function, frequency, and amplitude for the burst.
For bursts, you can select sine, square, triangle, ramp, or arbitrary
waveforms. For this example, select a 1 kHz sine wave with an output
amplitude of 5 Vpp .
Shift
Burst
2 Enable the burst mode.
Notice that the
Shift
3 Use the menu to set the burst count.
<
After you enable the burst mode, the "recall menu" key will
Recall Menu
automatically take you to the
annunciator turns on.
Burst
4: BURST CNT
command in the
BURST CNT
2
.
MOD MENU
47
Advertisement
Table of Contents
