GE MDS SD Series Technical Manual page 74
Secure, long range ip/ethernet & serial wireless transceiver
Hide thumbs
Also See for MDS SD Series:
- Reference manual (148 pages) ,
- Technical manual (124 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
8 character bits, even parity, 2 stop bits
7 character bits, no parity, 1 stop bit
7 character bits, no parity, 2 stop bits
7 character bits, odd parity, 1 stop bit
7 character bits, odd parity, 2 stop bits
7 character bits, even parity, 1 stop bit
7 character bits, even parity, 2 stop bits
•
— The transceiver's buffer provides a way of handling data "over-runs," where
Buffer
more data is passing through the
When the buffer is on, any such data is stored up and processed in the appropriate order.
Available selections are
•
— This user input controls the amount of time in ms that data will be buffered
Buffer Delay
before being sent to the modem for processing. Default 0 range is 0-255 ms.
•
— This value controls the device behavior of the radio. In DCE mode, CTS will
Device
go high following RTS, subject to the CTS. CTS KEY mode, the unit is assumed to be
controlling another radio. The radio will still key based on the RTS line, but the CTS line
is used as a key-line control for an external radio. CTS is asserted following the receipt of
RF data, but not until after the CTS programmable time has expired. (This gives the other
radio time to key.)
•
Talk on/Listen to
in these fields. For more information on how these settings are used, refer to the SD Seri-
al/Telnet Management Supplement, Part No. 05-6193A01 more information.
•
Term Srvr Status
NOTE The radio can operate in RS-422 mode when RS-485 is selected.
IP Configuration
The
screens contain various settings for the IP data stream. Each item is listed be-
IP Configuration
low along with an explanation of the parameter. Note that the top of the screen displays the cur-
rent settings that have been applied to the radio in a read-only fashion.
When VLAN mode is set to anything other than
the
should be specified in the
Mgmt VLAN
•
Current IP Address
•
Current Subnet Mask
64
COM2
Data Handling ON
— Any combination of the three Virtual Radio Channels may be entered
— Indicates whether the radio's terminal server is enabled or disabled.
IP Configuration
— Read-only indication of the current IP address programmed.
— Read-only indication of the subnet mask programmed.
SD Series Technical Manual
port than can be immediately handled by the unit.
or
Data Handling OFF
, the IP address of the radio as seen by
Disabled
menu.
.
MDS 05-4846A01, Rev. I
- Quick Links:
- Com1 (Serial) Connection
- Led Indicators
Hide quick links:
Advertisement
Table of Contents
