Interface Configuration; Figure 132: Mld Snooping Interface Configuration; Table 116: Mld Snooping Interface Configuration Fields - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Table 115: MLD Snooping Global Configuration and Status Fields (Cont.)

Data Frames Forwarded by

VLAN Ids Enabled For MLD

• Select Enable or Disable the Admin Mode field and click Submit to turn the feature on or off. Perform a

save if you want the changes to remain in effect over a power cycle.

Interface Configuration

Use the MLD Snooping Interface Configuration page to configure snooping settings on specific interfaces.

To access the MLD Snooping Interface Configuration page, click LAN > L2 Features > MLD Snooping > Interface

Configuration in the navigation tree.

Group Membership Interval

Max Response Time

Shows the number of data frames forwarded by the CPU.

Displays VLAN Ids enabled for MLD snooping. To enable interfaces for MLD

snooping, see

"VLAN Configuration" on page

Select the physical or LAG interfaces to configure.

Select the interface mode for the selected interface for MLD Snooping for the

switch from the pulldown menu. The default is Disable.

Specify the amount of time you want the switch to wait for a report for a

particular group on a particular interface before it deletes that interface from

the group. The valid range is from (2 to 3600) seconds. The default is 260

Specify the amount of time you want the switch to wait after sending a query

on an interface because it did not receive a report for a particular group on

that interface. Enter a value greater or equal to 1 and less than the Group

Membership Interval in seconds. The default is 10 seconds. The configured

value must be less than the Group Membership Interval.

Configuring MLD Snooping

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents